I have problems with DATA EXTRACTOR V 5.7.8
When I create the image. in the process of running a lot of times the process stops with the message.
Hardware reset
Software reset...
Hardware reset
10/11/2018 10:24:44 PM - Execution of all processes is aborted!
****************** Scan process ***********************************************
start time 10/11/2018 10:24:19 PM
finish time 10/11/2018 10:24:44 PM
-------------------------------------------------
I ran again and it worked but after a while it stopped.
In the old version of DATA EXTRACTOR I did not this error.
Does anyone have faults like me. And any solution to this problem ????
I have problems with DATA EXTRACTOR V5.7 "Execution of all processes is aborted!"
Moderator: Dmitriy_TS
- cuumaytinh
- New user
- Posts: 55
- Joined: 19.08.13
- Reputation: 2 / (19)
Re: I have problems with DATA EXTRACTOR V5.7 "Execution of all processes is aborted!"
Did you submit a support request with ACE to have them help troubleshoot?
Re: I have problems with DATA EXTRACTOR V5.7 "Execution of all processes is aborted!"
This is normal, if after Hardware Reset your drive didn't come ready.
- cuumaytinh
- New user
- Posts: 55
- Joined: 19.08.13
- Reputation: 2 / (19)
Re: I have problems with DATA EXTRACTOR V5.7 "Execution of all processes is aborted!"
northwind wrote:Source of the post This is normal, if after Hardware Reset your drive didn't come ready.
it ready after Hardreset.
Re: I have problems with DATA EXTRACTOR V5.7 "Execution of all processes is aborted!"
Unless timeout settings in DE are shorter than time it takes to show ready
- cuumaytinh
- New user
- Posts: 55
- Joined: 19.08.13
- Reputation: 2 / (19)
Re: I have problems with DATA EXTRACTOR V5.7 "Execution of all processes is aborted!"
AJ2008 wrote:Source of the post Unless timeout settings in DE are shorter than time it takes to show ready
i never saw error in old version DE. time set is same old version
- Dmitriy_TS
- Site Admin
- Posts: 298
- Joined: 01.04.13
- Reputation: 8 / (78)
Re: I have problems with DATA EXTRACTOR V5.7 "Execution of all processes is aborted!"
I would recommend you to install the latest version of PC-3000 and repeat these steps on a new version.
With best regards
ACELab technical support
ts.acelaboratory.com
blog.acelaboratory.com
ACELab technical support
ts.acelaboratory.com
blog.acelaboratory.com
Who is online
Users browsing this forum: No registered users and 2 guests