ST1000LM035 - no ID after ROM swap

Moderator: Dmitriy_TS


AdasRip
Newbie
Posts: 47
Joined: 28.04.14
Reputation: 2 / (17)

ST1000LM035 - no ID after ROM swap

Postby AdasRip » 03.09.20, 16:36

I got ST1000LM035 with a burnt PCB.
I changed the ROM and the disk goes to DRD state. However, it does not report an ID.
Does this model have SED?

Terminal show:

Code: Select all

Boot 0x80M
QB
Rst 0x80MSrv DETCR init 0x0000
FTU
PrgF
(P) SATA Reset

RAW OFF
 PASS
(DOS Table) Worst Count: 00000000 At SU: FFFFFFFF NT: 00000000 OT: 00000000
MSP213
(MC POR Duration): 000000004F
Intel 6G->3G
Send Status: COMRESET seen
CSpd= 3Gbps
DSC
FAFH_TRIGGER_POWER_UP


AJ2008
Posts: 1340
Joined: 25.11.08
Reputation: 11 / (105)

Re: ST1000LM035 - no ID after ROM swap

Postby AJ2008 » 04.09.20, 11:02

terminal looks ok here - check sata cable. do you see DSC + DRD register? Or you see DWF flag when trying to read ID maybe?


AdasRip
Newbie
Posts: 47
Joined: 28.04.14
Reputation: 2 / (17)

Re: ST1000LM035 - no ID after ROM swap

Postby AdasRip » 04.09.20, 21:07

At the beginning I have only DRY and DSC.
After any read operation my drive status is: DRY DWF DSC ERR ABR.


AJ2008
Posts: 1340
Joined: 25.11.08
Reputation: 11 / (105)

Re: ST1000LM035 - no ID after ROM swap

Postby AJ2008 » 08.09.20, 11:07

DWF - Drive Write Fault - device fault state is active and no operation over ATA is possible. This can be patched via patching RAM or SA to give data access. The safest option is patching RAM which can be done through CFW overlay in PC3000


Maxim_TS
Site Admin
Posts: 325
Joined: 27.03.13
Reputation: 16 / (160)

Re: ST1000LM035 - no ID after ROM swap

Postby Maxim_TS » 22.10.20, 18:50

With best regards
ACELab technical support
ts.acelaboratory.com
blog.acelaboratory.com


Return to “Arch F3”

Who is online

Users browsing this forum: No registered users and 1 guest