ST8000DM004

Moderator: Dmitriy_TS


msurgeon
New user
Posts: 61
Joined: 14.02.12
Reputation: 2 / (21)

ST8000DM004

Postby msurgeon » 05.05.20, 21:28

Apparently this is Lamar family. Drive spins up, heads leave ramp, beeps once, spins down in RDY mode with heads parked back on ramp. No obvious platter or head damage. Terminal gives a couple of lines of FAIL servo op information. Is this an obvious head issue or is it something about this drive family for which the new update is required? Thanks for some direction.

User avatar
digitalsupport
New user
Posts: 140
Joined: 30.12.11
Reputation: 4 / (41)

Re: ST8000DM004

Postby digitalsupport » 06.05.20, 06:14

Typical head issue on these. Inspection of HSA and ramp under microscope will most likely reweal the course.


Maxim_TS
Site Admin
Posts: 316
Joined: 27.03.13
Reputation: 16 / (156)

Re: ST8000DM004

Postby Maxim_TS » 21.05.20, 16:47

By the way, 8B Lamarr family has been added to 6.7 update. Head map editing is not recommended for new drives, so head swap is the only way.
With best regards
ACELab technical support
ts.acelaboratory.com
blog.acelaboratory.com


osity
User
Posts: 363
Joined: 06.12.15
Reputation: 4 / (38)

Re: ST8000DM004

Postby osity » Yesterday, 22:07

Maxim_TS
I understand that Head map EDITING is not recommended.
Is it possible to do a simple head map on this family? I tried but it locks up PC3K.


Return to “Arch F3”

Who is online

Users browsing this forum: No registered users and 2 guests